LynCAN – WIO

LynCAN – WIO I/O module is designed to have all the necessary I/O interfaces that can be used in a fiber laser cutting machine. If onboard I/O on one module is not enough, up to three can be used simultaneously. In this case the first one acts as an ethernet can gateway. LynCAN wio can be installed in the electrical cabinet via DIN rails.

I/O signal list:

  • 16 x digital outputs

  • 24 x digital inputs

  • 4 x analog inputs

  • 2 x analog outputs

  • 2 x pwm outputs

  • 1 x current input

  • 1 x RS232 connection

  • 2 x CanBUS connection

  • 1 x RJ45 Ethernet connection

Power supply21 - 27 VDC
Power consumptionMinimum 150mA, 24V DC (logic)
Digital outputs16 short-circuit protected digital outputs
I ≤ 100mA for each digital output, 24 VDC
Digital inputs24 Digital inputs, 24 VDC
Analog inputs4 Analog inputs, 0 - 10 VDC
12 bits resolution
Analog outputs2 Analog outputs, 0 - 10 VDC
12 bits resolution
PWM outputs2 PWM outputs, 0 -24 VDC
16 bits resolution, 0 - 20 kHz, short-circuit protected
Current input1 Current Input, 0 – 20 mA
12 bits resolution
Interfaces1 Ethernet Connection
1 RS232 Connection
2 CAN Bus Connection (2 x RJ45)
FeaturesLED indication for each output
LED indication for each input
LED indication of power on/off condition
Short circuit proof at digital outputs
Reverse polarity protection
Ambient temperature rangeMinimum -10 °C, maximum +50 °C
ConnectionsScrew terminals for AWG 16-30 Wire
Dimensions125mm x 235mm
Weight450 gr